Zema profila puspiekabe

FAYMONVILLE MAX Trailer MAX100 Semi-Tieflader 2tlg. Rampen

You can find our complete range of vehicles with immediately and shortly available units on our website.

Equipment highlights (full equipment details available on request):

Gooseneck
* Gooseneck with rear taper approx. 750 mm x 10°
* 3 pairs of lashing rings (LC 5,000 daN)
* Hardwood flooring approx. 30 mm thick
* Loading platform after the gooseneck hydraulically raisable and lowerable, length approx. 2,800 mm, with rear taper approx. 1,000 mm x 8°
* 6 pairs of fold-out lashing rings to the outside (LC 5,000 daN)
* 2 pairs of fold-out lashing rings to the outside (LC 10,000 daN)
* 1 pair of fold-in lashing rings to the inside on the front centre beam (LC 10,000 daN)
* Grating cover C40/4 (point load approx. 2.3 t on approx. 20 x 20 cm area) above axles; tread plate covering

Two-piece steel ramps
* One pair of galvanized, reinforced two-piece steel ramps, approx. 3,185 + 1,420 x 1,250 mm, with grating cover C40/5 (point load approx. 8 t on approx. 20 x 20 cm area)
* Ramp with hydraulically foldable ramp segments and hydraulic lifting gear, maximum load per pair: 40,000 kg
* According to Regulation 1230/2012/EU, ramps shorter than 300 mm in driving position are not counted towards the vehicle length of 16,500 mm

Landing legs
* JOST landing legs (mechanical) with two-speed gearbox for approx. 24 t lifting capacity (approx. 50 t test load)
* Tyres 235/75 R 17.5 3PMSF
* TPMS tyre pressure monitoring system according to ECE R 141

Axles
* BPW axles and suspension
* 2 rigid axles, 1 trailing axle
* Technical axle load: 12,000 kg each
* Electromagnetic reverse lock, activated via reverse gear and manually
* Air suspension with raising and lowering valve

Brake system
* WABCO brake system in compliance with EU regulations with EBS-E (2S2M)

Colors
* Trailer RAL 3002 carmine red
* Rims silver
* Tarp in RAL 9006 silver

Including accessories
* 1 spare wheel carrier under the loading platform, right-hand side
Tsdpfsxttc Nox Abzod
* 2-inch kingpin
* One galvanized steel front wall
* Yellow-red air couplings on the galvanized front connection strip
* 4 wheel chocks with holders on the front wall
* 3 height-adjustable wooden boards
* Galvanized folding supports under the rear taper of the loading platform
* Height-adjustable tarpaulin frame approx. 3,960 mm
* Galvanized front wall with tensioning system for the sliding curtains
* Height-adjustable roof by EDSCHA, adjustable by approx. 400 mm, shiftable to the front on aluminium roof beam profiles (bolted to front and rear wall)
* 3 pairs of movable stanchions in the loading area
* Structure hydraulically extendable at the rear by approx. 750 mm on both left and right
* Sliding curtain with approx. 700 mm length reserve, with tension straps at approx. 600 mm intervals in height
* Upper structure height approx. 3,960 mm (loaded)
* Driving with open sliding roof is not permitted and will result in tarp damage
* Anti-slip sand coating painted onto the tread plate at gooseneck and loading platform
* Cover plates to bridge the gap between ramps and loading platform
* Electro-hydraulic unit at the rear underneath the loading platform
* At the gooseneck and ramps left and right, each with holder for warning signs, including socket
* Operating valves for the ramps installed on the right-hand side of the trailer
* Grating cover in the gooseneck rear taper C30/3 (point load approx. 2 t on an area of 20 x 20 cm)
* Grating cover in the loading platform rear taper C4

Sludinājums tika tulkots automātiski, tāpēc tajā varētu būt dažas tulkošanas kļūdas.