Atvērta puspiekabe ar tentu

FLIEGL Gardinensattel Standard

The images are archive photos! The vehicle may still be in use!

Chassis Semi-Trailer Forwarder
Fine-grain steel welded construction, fifth wheel plate with replaceable 2" kingpin
Outer frame slightly sloped with "Load-Lock profile" for lashing strap attachment.
Note! To attach the straps in combination with sideboards, the sideboards must be opened!
24t, 2-speed landing gear, single-sided operation, with straight base, without compensating slide
Pull-out ladder at the rear
Side door retainers
2x wheel chocks with holder
Attention! Only Chassis No. 2024286 - 89: Pallet box for 30 Euro pallets (ground clearance approx. 220 mm)
Underrun protection, galvanized steel
Quarter-mudguards in front of and behind axle assembly
With EC-compliant anti-spray flaps
Rear impact protection
Plastic toolbox with drawer and shelf, w=650 / h=520 / d=670 mm, can be locked with a padlock (padlock not included)

Axles + Suspension
SAF axles
"Axle/chassis laser aligned" reduces tire wear and fuel consumption
Air suspension
1st axle with automatic lift axle, including forced lowering and starting aid, activated by "brake 3x" (starting aid functions up to a 30% axle overload and up to max. 25 km/h)

Brake system
2-line compressed air brake system, color-coded lines for easy servicing.
Spring-type parking brake
2 fail-safe coupling heads at the front, without connecting line
EBS, electronic brake system with EBS socket at the front, without connection cable
Note: The trailer may only be towed by towing vehicles that ensure the effectiveness of the ABS!
With raise & lower valve
Vehicle stability control system

Wheels and Tyres
385/65 R22.5, manufacturer at the manufacturer's discretion
Steel rims, factory silver

Electrics
24 Volt, multi-chamber lights, yellow LED side marker lights
2 white position lights at the front
2 white/red lane control lights at the rear
2 x 7-pin and 1 x 15-pin fail-safe sockets at the front, without connection cable

Front bulkhead / corner stanchions
2, 580mm high, steel corner stanchions in volume design, release mechanism for side curtain at the front bulkhead
"Crash-blocker", internal steel impact protection at about 140mm height

Center stanchions
3 pairs of sliding stanchions movable along the full length, with 4 insert pockets and a long pocket at bottom
3 pairs of stanchion positions

Rear wall / rear corner stanchions
Rear corner stanchions up to the lower edge of the roof, curtain attachment with round tube and ratchet tensioner
Rear portal doors, two-leaf, each with two internal rotary bolt locks

Tarpaulin
Tarpaulin with integrated horizontal and vertical belts
Tension latches made of stainless steel

Roof
Sliding roof, rear liftable end, can be slid from rear to front, tarpaulin color: white
Hjdpjy Dfprjfx Abfsff
Optimized rain gutter at rear, on top of the rear bow, above the doors

Operating instructions
When assembling combinations, ensure compliance with the legally permitted overall vehicle height!
If the total height exceeds 4,000 mm, please observe the following:
The transport contractor is responsible for any resulting damages.
The transfer agent must obtain permission according to § 29 StVO
We assume no liability for the transfer of the vehicles.

The images are archive photos! The vehicle may still be in use!

Sludinājums tika automātiski tulkots. Iespējamas tulkošanas kļūdas.