Zema profila puspiekabe

MÜLLER-MITTELTAL Tieflader TS3-RM ML30,0 mit Radmulden Lenkachse

Müller-Mitteltal Lowboy Trailer with Wheel Recesses TS 3 RM ML 30.0, 2 Loading Heights, and Ramps

* Fifth wheel load capacity increased from 12 t to 18 t, including:
Fifth wheel mounted in: Second fifth wheel position, 2", fifth wheel up to and including
Kingpin distance 2,750 mm. Rear swing radius approx. 2,400 mm in clear space
(a minimum clearance of 150 mm is recommended). Front swing radius
1,480 mm or 1,570 mm with spare wheel. Note: Sufficient clearance to the
tow vehicle must be ensured by the customer.
Hodpfxey R Ipus Abkep

* Retractable sections for the wheel recesses at the front and bottom at the rear (205 mm deep). 6 pieces of decking for wheel recess holders as receiving shafts according to code 09.112. Aluminum compressed air tank instead of steel.

* Smartboard control box mounted on the trailer as an information tool with pressure sensors, ultimately for displaying the total axle load. Display option selectable either via the control box or in the truck via the EBS air suspension system (truck manufacturer dependent).

* ?SP Combination Package: Toolbox with 45° corners made of galvanized sheet steel, additionally powder-coated in RAL 9006 white aluminum, on the fifth wheel platform W=2,480 x H=500 mm with a hinged lid on top, side doors, and sloping sides on the left. Aluminum side walls that can be folded down to the fifth wheel platform (500 mm high), aluminum rear wall inserted (150 mm high), aluminum side walls painted inside and outside in RAL 9006 white aluminum. Including folding and detachable rear supports, galvanized (without top coat). Including bolted front extension. Length of front crossmember to kingpin distance 3,935 mm. Front swing radius, without spare wheel, at kingpin distance 2,450 mm or 2,750 mm approx. 1,750 mm or approx. 1,480 mm.
* 2 container locking mechanisms recessed into the front crossmember.

* 3 receiving shafts under the fifth wheel platform for storing optional aluminum ramps or wooden planks for covering the wheel recesses.

* Folding or extendable support legs (galvanized) and wooden planks for widening included (not on the rear slope). Plank holder on the fifth wheel platform (the gauge of the load may be a maximum of 2,500 mm).

* Second LED position light on the warning package at the front and rear (double lighting), only in conjunction with the warning package.

* 2 LED reversing lights on the rear of the trailer, switched with reverse gear (suitable for 12 V and 24 V), max. 2 additional lights allowed.

* 7-pin socket on the rear, wired for overlength lighting with rear light (58 R) and ground.

* Rubber covering on the access ramp on the left and right (approx. 860 mm long), 190 07644 rubber covering strip, on the inner plank of the single-piece ramps.

* Central lubrication system fully automatic with pump (24V), grease tank, and integrated trailer control, without connection to the ramps (in case of steering: including connection to the distributor on the fifth wheel platform). Note: Only possible with tow vehicles with a 24V electrical system!

Intermediate sale and errors are expressly reserved!

Sale exclusively subject to our general terms and conditions.

Important note – Important information: Despite careful checking of all details in our offer, it may happen that errors occur. In some cases, these are caused by transmission errors in the systems of the various platform providers. Therefore, we would like to point out that all information is p

Sludinājums tika automātiski tulkots. Iespējamas tulkošanas kļūdas.