Atvērtā puspiekabe

FLIEGL 2-Achs Mega Plateau Jumbo SZS 290

Customized transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are carried out individually according to customer requirements.

Chassis, semi-trailer, transport company
Fine-grained steel welded construction, turntable with replaceable 2" kingpin, reinforced mounting point for "gallows" attachment, and with sturdy wear plates all around, attachment rail for aluminum ramps at the rear
Outer frame slightly inclined, new design with "Load-Lock profile" for securing lashing straps, "patented Load-Lock cross" for securing lashing straps, in the cross member under the outer frame, 24-ton, two-speed support winch, single-sided operation, with straight lower part, without stroke compensation, free support foot angle or free swivel radius to the rear approx. 1920 mm, without supports, 2 shims with holder, aluminum side impact protection, steel under-run protection, quarter panel fenders in front of and behind each axle, without bull bar, spare wheel holder for 1 spare wheel, with wheel fastening kit, spare wheel, manufacturer same as standard tires, steel rim
Plastic toolbox, with insert, w=620/h=360/d=440 mm, lockable with a padlock
Axles + Suspension
Drum brake axles, "axle/chassis laser-aligned" to reduce tire wear and fuel consumption, without steering, air suspension, without lift axle
Braking system
2-line compressed air braking system, color-coded line routing for easy maintenance, spring-loaded parking brake
2 foolproof coupling heads at the front, without connecting line, EBS, electronic braking system with EBS socket at the front, without connecting cable, note: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS! with raising and lowering valve, vehicle stability system
Wheels and tires
205/65 R17.5, manufacturer's choice for 8-ton axle load at 80 km/h, steel rims, factory silver
Electrical system
24 volt, multi-chamber lights, yellow LED lighting on the sides, 2 white position lights at the front, 2 white/red marker lights at the rear, 1 x 15-pin socket at the front, without connecting cable, LED work lights in a curved design (switched via reversing light), if technically possible, additional LED work light at the rear, switched via reversing light
Floor
Sieve-printed panels approx. 30 mm thick, for high point load capacity for forklift axle load up to max. 5600 kg
Front wall / front corner posts
25 mm aluminum hollow profile, 1350 mm high, corner posts steel in full volume design

Customized transport solution
Nlsdpfx Afjzb Ikfsusd
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are carried out individually according to customer requirements.

Sludinājums tika automātiski tulkots. Iespējamas tulkošanas kļūdas.