Zema kravnes piekabe

MÜLLER-MITTELTAL T3 Tiefl., Luft., Schwarzdeckentransporte

* T3 Profile 30.0:
* EBS-E (electronic braking system)
Nodpotplv Njfx Aivswh
* TPMS (tire pressure monitoring system)
* Emergency release device for spring accumulators
* Drum brakes
* 3 x 11-ton BPW Eco axles
* Air suspension with lifting and lowering system
* SmartBoard as an information tool on the trailer with pressure sensors for displaying total axle load per axle group
* Lateral impact protection
* Mechanically adjustable warning sign packages at the front and rear
* Front axle: closed plastic mudguards, rear axle: straight, galvanized steel splash guards, each with splash protection
* Folding cover (hot-dip galvanized) for the toolbox in the turntable platform
* Toolbox made of galvanized sheet steel, approx. 650 x 300 x 600 mm (black powder-coated), on the right side
* 15-pole power connector
* LED lighting 12 / 24 V
* LED rotating beacon (removable) at the rear
* Side marker lights with turn signal control
* Drawbar with 40 mm drawbar eye and height adjustment via tension spring & locking pin
* Tire pressure monitoring system with display option in the truck via EBS signal (without truck-side installation)
* Rubber coating on the folding ramps as well as on the access ramp on the left and right (approx. 860 mm long)
* Rubber coating on the longitudinal beams from the front to the end crossbeam
* Hardwood flooring on the running surfaces of the low-loader platform
* 4 lashing pockets on each side with simultaneous 2-ton lashing capability
* Lashing package consisting of: 5 pairs of UVV lashing rings, swivel and lowerable, loadable in all directions and recessed in the outer frame - 13.4 tons in the corners, otherwise 10 tons
* 6 pairs of mechanical folding outriggers for a total width of 3 m (but not on the rear ramp)
* Plank holder under the loading area in the longitudinal direction
* Roller stop in front of the front crossbeam, raised, with 1 x 6.4-ton lashing eye on each side
* Hydraulic folding ramps (approx. 4,650 x 720 mm) with hydraulically extendable tip section and load-holding valves
* Hydraulic lateral ramp adjustment
* Hydraulic rear supports (single-stage cylinder)
* Hydraulic flow divider in the trailer (with hydraulic pump output in the truck of over 40 liters up to max. 140 liters/min)
* Hydraulics control block, splash-proof
* Two-line hydraulic system
* Loading area above the turntable: approx. 1,960 x 2,520 mm
* Rear loading area: approx. 6,500 x 2,520 mm (incl. 860 mm access ramp)
* Loading height loaded approx. 890 mm +/- 20 mm air suspension
* Chassis, turntable, roller stop, folding extensions & access ramps hot-dip galvanized
* Axles, turntable, drawbar, air tanks, etc. painted in black
* Loading height loaded: approx. 890mm +/- 20mm
* New vehicle with manufacturer's warranty
* Errors and prior sale are subject to change
* Available immediately from Egestorf

Sludinājums tika automātiski tulkots. Iespējamas tulkošanas kļūdas.