Trīspusējā pašizgāzēja piekabe

Fliegl Tandem-Seitenkipper TSK 118 - 5 Meter

Customized Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized to meet individual customer needs.

Chassis: Central axle tilting trailer
Steel welded construction, continuous tilting shaft at the rear with 80 mm ball bearing
Fsdszcv Stspfx Abnegc
Gear-supported front support leg
Foldable rear support
Wheel chocks with holder
Underrun protection, steel
Splash guards at the rear, covering the entire width (not in conjunction with forklift mount)
Quarter panel fenders
1 plastic toolbox, w=600 / h=425 / d=460 mm, lockable (lock not included)
Note! The side panel touches the storage box when folded down.
Lockable storage space for loading ramps below the loading area
Coupling device for central axle trailer
Drawbar with tested 40 mm tow hitch
Drawbar height adjustable via spindle, max. adjustment range 300 mm
Axles + Suspension
GFA or BPW axles, at the manufacturer's choice, with tapered roller bearing and S-cam brake
"Axle/chassis laser-aligned" - reduces tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load equalization (linkage equalization)
Wheels and Tires
235 / 75 R 17.5", manufacturer's choice
Steel rims, factory silver
Braking System
2-line compressed air braking system
Color-coded line routing for easy servicing
Handwheel-operated parking brake
24 Volt ABS and ALB, with ABS connector at the front, with connection cable
Note: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
2 fail-safe coupling heads at the front, with connection lines to the towing vehicle
Electrical System
12 to 24 Volts, multi-chamber lights in LED, yellow LED side lighting, license plate lighting in LED
2 white position lights at the front
2 white/red marker lights at the rear
2 x 7-pole fail-safe connectors at the front, with connection cable
Additional LED work lights at the rear, switched via reversing light
Hydraulics
Three-way tipper, hydraulic multi-piston cylinder with stroke limitation and safety cable
Low-pressure cylinder up to max. 170 bar, without throttle. If required, this must be retrofitted on the truck (truck with max. hydraulic flow rate of 55 l/min)
Hydraulic connection with SVK connector NW 10/3, including connection hose
Operation hydraulically via truck auxiliary drive
Tipping Platforms
Stable tipping platform with 4 mm steel sheet base, side panel construction in steel, side walls continuous, foldable and pivotally mounted with central locking at the bottom. Rear corner posts pluggable. Rear wall foldable and pivotally mounted, with central locking at the bottom.
Platform length approx. 5,000 mm, side walls with 6 hinges at the bottom.
Side panel retraction springs
Platform width 2420 mm
3 pairs of lashing eyes in the floor, each 5 tons
Paint Finish
Frame: Hot-dip galvanized including passivation
"15-year guarantee against rust through"
Side panels/platform: galvanized or painted according to customer requirements

Customized Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized to meet individual customer needs.

Sludinājums tika automātiski tulkots. Iespējamas tulkošanas kļūdas.