Zema kravnes piekabe

MÜLLER-MITTELTAL 18 t. Kombi Abroller Absetzer Tieflader, Luft

* TRA-Kombi 18.0:
Itedpfx Asl Tnwzsggor
* TPMS (Tire Pressure Monitoring System), display possible in the truck via EBS signal (no truck-side installation required)
* EBS-E (Electronic Braking System)
* Emergency release device for spring-loaded cylinders
* Drum brakes
* 2 x 10.5 ton axles
* Air suspension with manual lowering at the rear
* Pneumatically lowerable drawbar, 2,100 mm long, with 40 mm towing eye and height adjustment device
* Tool box made of powder-coated sheet steel, plus spare wheel holder in basket design on the right side
* Reflective contour marking strips on the sides and rear
* Closed side underrun protection
* Plastic quarter mudguards with spray protection
* Plastic rear impact protection buffers
* Foldable A-board at the rear
* LED rear lights
* 15-pin power connector
* Hot-dip galvanized main frame with raised outer frame for guiding roll-off containers
* Sheet steel floor with roller recesses in the bogie area
* For roll-off container transport: container length from 5,500 to 7,000 mm possible
* Pneumatic 4-point container locking system and mechanically insertable stop angles at the front on the track
* Load securing certificate according to DIN 30722-1
* 1 transport of up to 2 skip containers with max. 10 m³ volume possible
* Includes 8 repositionable skip stops for lateral centering of skips, front 4 skip stops are plug-in with pivoting stops
* 3 pairs of 10 t UVV lashing rings on the sides for attaching tensioning devices for positive and non-positive securing of skips; 4 lashing cleats each in cloverleaf design (side) and 1 pair of 13.4 t UVV lashing rings at the front
* Load securing package with an additional 4 x 8 t lashing eyes per side recessed into the outer frame
* Load securing certificate according to DIN EN 12195-1, DIN EN 12640, DIN EN 12642, and VDI 2700
* Weld seam as anti-slip surface in the ramp area of the approach slope
* Mechanical drop-down supports at the rear
* Aluminum loading ramps (10.6 t/pair) 2,800 x 470 mm suitable for rubber-tired and tracked vehicles (lockable storage compartment accessible from the rear)
* --Permissible total weight technically possible: 20,000 kg--
* New vehicle without initial registration with manufacturer’s warranty
* Subject to errors and prior sale
* Immediately available ex Egstorf

Sludinājums tika tulkots automātiski, tāpēc tajā varētu būt dažas tulkošanas kļūdas.