Rullplatformas piekabe

MÜLLER-MITTELTAL 18 t.Außenroller Container Anhänger, 2 in 1

* TRA 18.0:
* 2-in-1: suitable for roll-off containers and as low-loader
* TPMS (Tire Pressure Monitoring System)
* EBS electronic braking system
* Emergency release device for spring brake cylinders
* Drum brakes
* 2 x 10-ton axles
* Air suspension with manual lowering at the rear
* Drawbar 2,000 mm long with 40 mm towing eye and adjustable height
Bodpfx Asl Tpc Ajbzelp
* Tool box made of powder-coated steel sheet approx. 1,000 x 300 x 600 mm and spare wheel holder in basket design on the right side
* Contour marking tape, reflective on sides & rear
* Side underrun protection
* Plastic quarter mudguards with spray protection
* Plastic rear bumper pads
* Foldable A-board at the rear
* LED tail lights
* 15-pin electrical connector
* Main frame with raised outer frame for guiding roll-off containers
* Steel floor plate with roller recesses in the bogie area
* Container length from 5,500 to 7,000 mm possible
* Pneumatic 4-point locking system and mechanical locking angles at the front in the guide rail, load securing certificate according to DIN 30722-1
* Lashing package including: 1 pair of 10 t. UVV lashing rings at the front wall carrier and 3 pairs of 10 t. UVV lashing rings on the side outer frame, each side with 4 x 2 t. cloverleaf type lashing eyes and 4 x 8 t. lashing lugs recessed into the outer frame
* Welded seam as anti-slip surface in the ramp area
* Mechanical drop-down supports at the rear
* 1 pair aluminum approach ramps (10.6 t/pair) 2,800 x 470 mm suitable for rubber-tyred and tracked vehicles (lockable storage compartment accessible from the rear)
* Chassis, bogie, locking components, and rear drop-down supports hot-dip galvanized
* Drawbar, axles, and air tanks finished in black
* New vehicle without initial registration, full manufacturer warranty
* Subject to errors and prior sale
* Available from calendar week 05 / 2026

Sludinājums tika tulkots automātiski, tāpēc tajā varētu būt dažas tulkošanas kļūdas.